A burst or leaking water line is the first thing to stop
If water is spraying or running from a pipe, turn off the breaker for the well pump. Then close the valve on the line just past the pressure tank, which is usually where the water line runs out to the rest of the house. The tank still holds water under pressure, so the leak will slow before it stops. Open the lowest cold tap in the house to drain what is left in the lines.
If water is near an outlet, a light fitting or the electrical panel, keep away from it. Turn off the breaker for that part of the house only if you can reach the panel while standing somewhere dry. Move what you can off the floor and take photos for your insurer. Once the water is off, the damage stops growing and the rest of the job can be done carefully.
In Alma's oldest houses, on Peel Street West, Church Street and Simpson Street, the water lines were often added long after the house was built and are usually galvanized steel. That pipe corrodes from the inside, and a split or a weeping joint is often the first sign. Houses from the 1930s to the 1950s may have early copper, which tends to fail as small pinhole leaks. Both are repaired the same way at first: stop the water, then cut out the failed section and look at what is on either side of it.
Frozen lines turn up in the coldest weeks of winter
Environment Canada's 1981 to 2010 normals for the Fergus Shand Dam station, near Alma, give a January mean daily minimum of −11.1 °C and a record low of −35 °C. That is cold enough to freeze water lines in crawl spaces, along outside walls and in unheated well pits. The usual signs are a tap that gives a trickle or nothing at all, a pump that runs without building pressure, or frost on a pipe you can see.
If you suspect a frozen line, turn off the well pump breaker so the pump does not run dry, and open the tap the line feeds. Warm the space gently by opening cabinet doors or letting heat into the crawl space. Never use an open flame on a pipe, and do not leave a heater running next to it without watching. A pipe that has frozen may already be split, and the leak only shows once it thaws. Keep the shut-off within reach while it warms.
A frozen line in a well pit, or the buried pipe between the well and the house, is harder to reach. Leave that one to the plumber, who will look for where the cold is getting in as well as the frozen section.
A septic backup calls for easing off the water
When the lowest drain in the house, often a basement floor drain or a shower, fills with dirty water, or several fixtures gurgle and drain slowly together, the problem is in the main line or at the septic tank. Stop using water: no laundry, no dishwasher, no showers, and flush only if you must. Every litre that goes down the drain has nowhere to go. Do not pour anything into the drain to try to clear it, because what harms the blockage can also harm the septic system.
The plumber will first work out whether the blockage is in the house drain, in the pipe out to the tank or at the tank itself. In older Alma houses that pipe is often cast iron or clay, and roots and broken joints are common causes. A clogged line is cleared by snake or water jet, as described under drain cleaning. If the tank is full, it needs pumping by a septic service before the drains will run again. Where the line itself is damaged, a camera check leads to the options under sewer repair.
An overflowing toilet or a leaking water heater can usually be contained
For a toilet that is running over, turn the small valve on the supply line behind it clockwise until it stops. If the valve will not move, lift the tank lid and raise the float to stop the fill, then shut the water off at the pressure tank. If the bowl will not drain and other fixtures are slow too, treat it as a backup and ease off the water.
A water heater leaking from the base should have its cold supply valve closed. For an electric heater, turn off its breaker as well. For a gas heater, turn the control to its off or pilot setting. If you smell gas, leave the house and call the gas utility from outside. Gas work is performed by TSSA-certified gas technicians. More on repair and replacement is under water heaters.
Some problems are safe to leave until the morning
A dripping tap, a toilet that runs on after flushing, or one slow sink while everything else drains normally can usually wait. The same goes for a small leak you can catch in a bucket once you have closed the valve feeding it. If a sump pump has stopped during a spring thaw and water is rising toward the floor, that is urgent. See sump pumps for what to check first. When you call, describe what the water is doing and what you have already shut off, so we can decide whether the visit should happen now or can be booked.
What the plumber does on an emergency visit
The first job is to confirm that the water is off and the area is safe. Next, the plumber finds the source: the split pipe, the frozen run, the blockage in the line to the tank or the failed fitting. Before any repair starts, you see the price in writing and decide whether to go ahead. Sometimes a temporary repair makes sense for the night, with a fuller fix to follow, and the plumber will explain why. Work is performed by licensed plumbers (306A Certificate of Qualification).
If the repair means changing a drain, a building permit may be needed, and the township building department decides which jobs require one. If the work means digging, for example to reach the line between the well and the house, a locate is requested through Ontario Dig Authority first. Public locates do not mark private lines such as your own water line or the pipe to your septic tank, so the plumber traces those separately. Repairs that can wait for daylight are listed under plumbing repairs.
