Skip to content
Alma Plumber

About Alma Plumber

Plumbing explained the way it works in a house on a well

Most houses around Alma run on their own water: a well, a pump, a pressure tank, and a septic tank at the end of the drain. Much of what is written about plumbing assumes a water main and a sewer at the street, so it skips the parts that matter here. Alma Plumber starts with your system instead. The first questions on a call are where the pressure tank sits, whether the basement has a sump or a floor drain, and roughly how old the house is.

Before anyone arrives, you are told what is safe to do now. For a leak or a burst line, that usually means closing the valve beside the pressure tank and switching off the well pump at its breaker. For a slow or backing-up drain, it means easing up on water use so the septic tank is not loaded further. If something should not be touched, such as a gas appliance or water close to the electrical panel, you are told that plainly and asked to leave it alone.

On site, the plumber starts with the symptoms and then looks at the pipe behind them. Houses from the 1850s to the 1890s near Peel Street West, Church Street and Simpson Street were built before indoor plumbing, so most were later fitted with galvanized steel water lines that narrow with rust, and cast-iron and clay drains to the septic tank. Houses that filled in along Wellington Road 7 and Wellington Road 17 often have early copper that develops pinhole leaks, and a floor drain where a sump would be today. Homes plumbed to current practice, like those planned off Wellington Road 17, use plastic pipe and depend on a sump pump, a well pump and a pressure tank. Knowing which you have narrows down where to look.

Once the cause is clear, you get a written price and you decide. If a repair will hold, you hear that. If the pipe around it is near the end of its life, you are shown why and given the choice. Drains that run to a septic tank are cleared by snake or water jet, with nothing poured into the line. Where a job needs a building permit or digging, the permit question and the locate come first. If you would like to read before you call, the guides cover emergencies, drain cleaning on septic and choosing a water heater for a house on a well.

The lead plumber of Alma Plumber in front of the service van

How the work is done

  • Work is performed by licensed plumbers (306A Certificate of Qualification).
  • For gas water heaters, gas work is performed by TSSA-certified gas technicians.
  • Hot water at the shower and tub is set no higher than the 49 °C limit in Ontario's Building Code.
  • Drains on a septic system are cleared mechanically, with nothing added that could harm the tank.
  • A locate is requested through Ontario Dig Authority before any digging.
  • New plumbing and drain changes are checked with the building department for a permit.

Tell us what the water is doing

Call or send the form with a few details. You get a written price to approve before any work begins.